The potential difference between a phase and neutral is 230v , but the potenti

The potential difference between a phase and neutral is
230v , but the potential difference between two phases is
400v. why?

Question Posted / vignesh

4 Answers
21819 Views
HCL, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

The potential difference between a phase and neutral is 230v , but the potential difference betwee..

Answer / mohan

phase to phase displacement is 120degree and magnitude
same.but nutral voltage is zero

Is This Answer Correct ?

22 Yes

3 No

The potential difference between a phase and neutral is 230v , but the potential difference betwee..

Answer / saurabh

the difference is given by under root of 3 becoz wen supply
is differntiated den the phase difference becomes the root3

Is This Answer Correct ?

9 Yes

2 No

The potential difference between a phase and neutral is 230v , but the potential difference betwee..

Answer / ravi teja.a

phase to phase displacement is 120degree and phase to phase
means the system is in delta connection.where as phase to
neutral means the system in star connection.in this star
connection phase to neutral voltage is 440/1.732(Root
3),i.e., single phase connection.

Is This Answer Correct ?

4 Yes

7 No

The potential difference between a phase and neutral is 230v , but the potential difference betwee..

Answer / m.senthil

It happens due to ohms value of the copper/aluminum conductor of the winding. The ohmic value of phase to neutral is less than phase to phase. Total impedance of the circuit, Z=root of R square+ XL square

Is This Answer Correct ?

0 Yes

4 No

Post New Answer

More Electrical Engineering Interview Questions

how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .

0 Answers Birla,

how to select the isolation tranformer for siemens 802dsl cnotroller

0 Answers Siemens,

what do u mean by starting torque? how it should be for a good motor? what is the relation between starting torque and power factor? What is the relation between efficiency and starting torque?

2 Answers

What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.

0 Answers

can v rotate single phase induction motor in both the direction...?

1 Answers

For testing 33kv cable hipot testing. How much kv we have to Apply .Give in details.

24 Answers

what is brushless alternator?

0 Answers

Explain principle of Soft-starter & how its working???

12 Answers MAHINDRA,

Why are you like to join it job as a electrical engineering student?

4 Answers Bhushan Power Steel,

how can we make cable shedule for controll wiring ? which details must be required for it.?