why DG battery blast
Answers were Sorted based on User's Feedback
Answer / shri..
While starting the engine the starter takes high current
from battery, while taking high current some gas produce in
battery compartment, if we filled the distill water more
than level where will gas goes out. So that we should
maintain distill water level & gravity.
| Is This Answer Correct ? | 10 Yes | 3 No |
Answer / loboreliance2003
Battery quality should be of renowned company. Connections
should be proper. Apply vaseline at the terminals. Ensure
tightness of terminals.
Hydrogen gas is produced during charging of battery. Hence
the enclosure should not be closed but should have proper
air ventilation so that the hydrogen gas produced should go
out to atmosphere.
If any spark then blast could occur.
| Is This Answer Correct ? | 3 Yes | 2 No |
difference between alternator & GENERATOR
why when i start my diesel generator it takes 1 minute or less then stop, and i checked the oil sensor is ok and when the generator start i can get 220 voltage but it it is stop after 1 minute or less, how can i solve this problem?
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
How to convert 2 phase to 3 phase electricpower in induction moter?
what type of motor are there in megger how they work.
draw vector diagram and +ve,zero sequence diagram of symmetrical three phase fault.
Explain principle of Soft-starter & how its working???
Why the voltage n frequency of the incoming generator is kept slightly higher than d grid voltage n frequency while synchronization ?
WHY THE FREQUENCY IS 50 HZ IN INDIA.CAN WE USE SOME OTHER FREQUENCY.IF SO WHAT IS THE RANGE AND WHAT WILL BE THE EFFECT IN PRESENT POWER SYSTEM IF WE CHANGE THE FREQUENCY AS YOU SUGGEST ?
32 Answers L&T, MCL,
purpose of breaker contact multiplication relay?
WHy neutral to ground trips when neutral touches the ground
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)