Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / loboreliance2003
Battery quality should be of renowned company. Connections
should be proper. Apply vaseline at the terminals. Ensure
tightness of terminals.
Hydrogen gas is produced during charging of battery. Hence
the enclosure should not be closed but should have proper
air ventilation so that the hydrogen gas produced should go
out to atmosphere.
If any spark then blast could occur.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
how can i get an electrical c-certificate?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
what are the main faults that occur in stabilizers? How they corrected and resolved ? Types of stabilizers ?
How is the gain affected by the introduction of feedback in a control system.
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
In HVDC LINE RECTIFIER CONTROL ON CONSTANT CURRENT AND INVERTER CONTROL CONSTANT EXITATION ANGLE CONTROL BUT HOW INVERTER CONTROL CONSTANT CURRENT?
what are the preventive maintanance actions taken for air circuit breaker? please answer me
pls tell me function of closing coil of A.C.B.
How do I calculate a WTI CT ofa 1250kVA 6600/400V transformer
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
v/f drive basic princeple
Importance of fault current in power transformers and how to monitor the same? How is it different from winding temperature?
how give earthing conection to household equipment?
Define damping ratio.
are there rmu for 3 transformer?
