Answer / sagar hingmire

Due to the leading power factor,system voltage(Bus Voltage)
wil get increased roughly around by 15 to 20 volts & it
will cause adrese effect on the m/cs operating. The
problems related to electronics card level, PLCs get
increased.

Answer / kapil

voltage regulation will become -ve, due to this stress on
all the equipments will increase in terms of voltage and
deteriorate the life of equipments...

Answer / l.veeraragavan

due leading power factor, the regulation of tr-line will be
negative.

can any tell me how to do wiring connection in L&T 3ph 4wire E301 CT operated energy meter, what is P1,P2,P3,P0. M1,M2,M3, L1,L2,L3.

2 Answers   Bhartiya International,

---

what is the difference between scaler and vector control in drive and where it is to be used ?

1 Answers   Essar, TCS,

---

what are the types of transformers

59 Answers  

---

difference between shunt coil and tripping coil

8 Answers   GE,

---

what is corona

3 Answers  

---

hi frnds.....anyone get any reply from HPCL. I HAVN'T.....B,COS written will b on FEB 17 th.

1 Answers   HPCL,

---

If one 10 Hp 3phase induction motor connected in 380volt 50Hz. and again its connected to 380volt 60Hz. howmuch currrent and power take on both time?????

1 Answers  

---

1600 KVA ka transformer hi aghar lt side par 800A aur voltage 420 ho to HT side ki cable ki rating keya ho gi?

0 Answers  

---

what is different between kvar & micro farad when its comes across the capacitor rating is it possible to convert kvar to mf or mf to kvar

1 Answers   Manipal University,

---

how to calculate insulation level of transformer?

0 Answers  

---

In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.

0 Answers  

---

At light load transformer efficiency is less because A secondary output is low B transformer losses are high C fixed loss is high compared to output D copper loss is small

1 Answers  

---