Answer / santosh

piles bear the load by two methods

1 skin friction developed between wall of piles &
surrounding soil transfer the load to the beneath the soil.
2 End bearing piles distribute the load.

Answer / sukhbir singh

Pileas are bear load by skin friction or transmitting load
on hard strata or combination of both.

Answer / mayur

1)by skin friction: skin friction type pile bear load by friction only as no good strata availabe below this type of pile

2)end bearing good strata is available below pile
thats why trasfer directly to strata by end of pile

what is the permanent solution applied for restoration of leaning tower of pisa?

0 Answers  

---

Dear Engineers, Can you please advise me the material requirement to construct a room 4 M x 4 M 1. No. of Standard Brick 2. Requirement of Cement Bags 3. And Concrete for Steel, Cement, sand, etc Thanks

0 Answers  

---

What happens to Load at yielding ?

0 Answers  

---

after temping in cbr mould keep how many hours mould in water

2 Answers  

---

what is construction joint? why do we give expancion joint in building?

4 Answers   jusco, L&T,

---

use ofr concrete as per grade ?

0 Answers   Qatar Petroleums,

---

What is the mix propotion of M10,M15,M20,M25,M30,M40,M50.M60 cement content,aggrigate,sand and water ratio.

0 Answers   L&T,

---

can you give me the details of rate analysis of steel and concrete?

0 Answers   L&T,

---

how amny bricks of size 240 mm X 120 mm X70 mm are required in 100 cubic meter brickwork. How much cement is required at 10 mm masonry and at 4:1 sand cement ratio and how much cubic meter of sand is required for the above work.

2 Answers   Cube Construction,

---

"Gates of the dams are generally designed of curved shape". Why?

0 Answers  

---

Sir please Bhel Enigineer trainy test papaers in civil engineering

1 Answers   Bhel,

---

sir when can we expect the AEE results and when will be the interviews sheduled please guide us in this regard thanking you

0 Answers   TCS,

---