Answer / madhusudhan

Kw= 1.732X Voltage X Current X pf. in these parameters only
current and pf are variable. The current limitation given on
the DG set is at that pf. if pf increases the current will
get decreased for the same KW. so you should monitor the
same pf as mentioned of DG set name plate or else you should
reverse calculate the current limitation at your load pf and
monitor the DG set no to get overloaded.

Answer / rajesh

I try this,



see,power factor is the percentage of resistive load in the
total circuit.as the power factor is one it indicates the
pure resistive which is real in number which can be
converted to the what ever the real energy we want like
rotatory motion etc...

frm:rajeshbeesetty@yahoo.com

Answer / balajieee

power factor is the cos angle between voltage&current.using
that nameplate pf value u can find kw capacity of a
generator for its kva rating(formula,p=sqrt3*v*i*cospi.).if
you are connecting pure resistive load means power factor
is unity,so the pf of generator will incrase from its name
plate value.capacitive load also incrase the pf of
generator.inductive load will decrease pf value.so the
average of resistive,inductive,capacitiveload pf ,name
plate pf will give final output pf of generator.

what can i do, if i want to carrier in design as i am electrical engg?

3 Answers  

---

Tell me harmfull effects of over voltage,under voltage,spike,surge,transient & noise.

1 Answers  

---

can we use heat gun instead of gas torch in 11kv termination kit. I mean can both sources provide enough amount of heat to ensure the uniform shrinkage of sleeve.

1 Answers  

---

What is the meaning of Dyn11 of Transformer.

17 Answers  

---

What is the required value while doing the megering

1 Answers  

---

what is the diffrence between dol and star delta strater? why star delta starter used instead of dol?

3 Answers  

---

I want d.g.set our company

0 Answers  

---

Utility company give the supply to customer in KVA but bill them for Watt.why?

1 Answers   L&T,

---

If single phase voltage level is 230V than why three phase voltage level is not 660V ?, but it is only 440V.

16 Answers   BSNL, DOS, EFS, HMT, L&T, TCS, ThyssenKrupp,

---

Why Magnetic Core Balance test is performed only on Star side of Transformer and not on Delta Side of Transformer (Vector Group Dyn11)?

1 Answers  

---

why transformer not work in dc

16 Answers  

---

in 4 pole lap wound dc motor one brush is disconnected then what result in new voltage if its voltage is v volts power is p watts current is i amp

1 Answers   GATE,

---