Interested to Buy Any Domain ? << Click Here >> for more details...
What do you mean by pf of a generator? Power factor purely
depends on the load (wether inductive, reactive or unity)
then what does the pf mentioned on the generator nameplate
means?
- 3 Answers
- 10419 Views
- I also Faced
- E-Mail Answers
Answer Posted / balajieee
power factor is the cos angle between voltage¤t.using
that nameplate pf value u can find kw capacity of a
generator for its kva rating(formula,p=sqrt3*v*i*cospi.).if
you are connecting pure resistive load means power factor
is unity,so the pf of generator will incrase from its name
plate value.capacitive load also incrase the pf of
generator.inductive load will decrease pf value.so the
average of resistive,inductive,capacitiveload pf ,name
plate pf will give final output pf of generator.
| Is This Answer Correct ? | 3 Yes | 13 No |
Post New Answer View All Answers
What should be the protection scheme for a 15kw, 3-phase motor working in a lathe machine.
what is difference between cpp electrical system and refinery electrical system
acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
A d.c. Shunt motor is found suitable to drive fans because they require?
Star Delta Diagram with full description
why we change the direction of winding in rotor ?how we make the north and south pole?
what is the meaning of osr in transformer.
List the power rating of any 5 important electrical appliances used in houses.
what is the meaning of impedance protected in instrument cooling fan
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
Can i replace Earth leakage relay to the faulty Earth Faulty Relay
