can we use heat gun instead of gas torch in 11kv termination kit. I mean can bot

can we use heat gun instead of gas torch in 11kv termination kit. I mean can both sources provide enough amount of heat to ensure the uniform shrinkage of sleeve.

Question Posted / wasifmecatech

1 Answers
2568 Views
I also Faced
E-Mail Answers

can we use heat gun instead of gas torch in 11kv termination kit. I mean can both sources provide en..

Answer / dadaso patil

Yes, we can use both of device for cable sleeving.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

What is spike & surge.

2 Answers

How Many Safety of Transformer

2 Answers

What are the causes for the failures of sandwich type (Al) busducts?

0 Answers

How to Calculate Stc Rating of an indoor type VCB Panel? What is a full form of STC?

1 Answers ABB,

What is the safe limit of voltage between earth and neutral in india.

2 Answers Incepta Pharmaceuticals,

Transmission through a short line depends on

0 Answers

11000volt DG set carnt kaise banvay

0 Answers AVK,

DISCUSS THE SHAFT MOUNTED D.C. GENERATOR ,BASED ON EXCITATION SYSTEM IN ELECTRICAL SYSTRM

2 Answers

How to test transformer

1 Answers

What is meant by Energy Efficient Transformers??? give significance

1 Answers MahaGenco,

A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.

0 Answers

what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group

0 Answers Bosch,

For more Electrical Engineering Interview Questions Click Here