what is mean by current
Answers were Sorted based on User's Feedback
Answer / electrical
Above answer is right but best definition is flow of charge
| Is This Answer Correct ? | 38 Yes | 9 No |
Answer / uma santosh
the flow of free electron is called current
| Is This Answer Correct ? | 12 Yes | 2 No |
Answer / praveen
above answers are correct but i just want to add one word
that is free electron.
flow of free electrons.
| Is This Answer Correct ? | 14 Yes | 5 No |
Answer / venky......
THE RATE FLOW OF ELECTRONS IN ANY CONDUCTOR IS CALLED
CURRENT.The unit of current AMPER
| Is This Answer Correct ? | 12 Yes | 4 No |
Answer / anusha
current is defined as the flow of free electrons or charge..
di=dq/dt.
| Is This Answer Correct ? | 11 Yes | 5 No |
Answer / guruvendrakumar
the rate of flow of free electrons(or)charges called current.
I=q/t.
| Is This Answer Correct ? | 6 Yes | 2 No |
Answer / manivannan
current mean by flow of electron charges is called current
| Is This Answer Correct ? | 4 Yes | 1 No |
How the main bus bar rating of 400kV switchyard with one and half breaker scheme is calculated.
What are linear elements and non linear elements? and I don't want answers with graph related
What is the range of efficiency of thermal or steam power plants? Why it is so low?
What is difference between start imitation and start interlock for 3 phase motor protection ?
whycircuit breaker is not connected at the generator end where the capacity of the generator is more say 60MW, 100MW etc.
What will happened, if field voltage change with 220 voltage to 110 voltage for a dc shunt motor?
How to Calculate Transformer Earthing Electrode Rod Size both Body and neutral Earthing ? Any Standard Formula? Please Suggted
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
what types of electrical & mechanical test conducted in switchyard?
6 MVA transformer secondary is rated for 725V at no load. The incommer ACB is rated at 690 V, 3200 Amp. Would there be any effect on performance of ACB due to lower voltage rating?
10Hp, 3-phase, 415v, 50Hz induction motor. The above motor is to run on Star-Delta connection, so how do i make following hardware selection 1) MCB, 2) Contactor, 3) Wire Gage (Depending on P-P current or Line Current), 4) OLR, Please tell in detail how to do the above, so as to get the ans. of it even if the Hp rating changes.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)