Answer / sudheer

we connect earth in all the machines to save machine and
man by electric shock. because the leakage current passes
to the earth by earthing wire.if we connect the earth wire
to neutral:- the leakage current will flow in the same
circuit and increase unbalancing.it is very dangerious for
man and machine.

Answer / venkatesh sastry

we connect earth in all the machines to save machine and
man by electric shock. because the leakage current passes
to the earth by earthing wire.if we connect the earth wire
to neutral:- the leakage current will flow in the same
circuit and increase unbalancing.it is very dangerious for
man and machine.


Thanks for Marking this Answer

Answer / sarmadahmed

The earth connection to neutral (or neutral grounding) has no disadvantage. In fact, it provides safety to the electric equipment. If neutral is solidly grounded then fault current for SLG fault will be greater than that of 3phase fault. So the protective devices should be of higher value. That could be the only disadvantage.

Answer / sivabalan.j

we connected earth & neutral by chance disconnect the both
wire then coming the return supply so ithing it's not
safety

Answer / sudhir saini

Threr is no disadvantage if earth is connected to neutral
it will be balncing load

Answer / manoj kumar tiwari

there is no any disadvantage ,if earth is connected with
neutral.

A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is

0 Answers   Caterpillar,

what will happen if i commission a transformer without connecting the neutral?

2 Answers   L&T, Sail,

how freewheeling diode improves the powerfactor

0 Answers  

how megger step up the DC voltage

1 Answers   Voltech,

what s a servo motor? how to control the servo motor? and its application, purpose of using?

2 Answers   Arabian Pipes,

Why the wave trap is put in Y phse only in switchyard?why not in other phases?

1 Answers  

why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?

0 Answers   Siemens,

We have AC-transformer 110/13.8kv,40MVA.If DC-Voltage=110kv is applied in its primary what will happen?

6 Answers  

What is dry and wet flashover.

1 Answers  

what is difference between single phase and three phase.

2 Answers   Birla,

How to connect the chemical earthing and complete process tell me plz

0 Answers  

how to work exciter in 10 MW alternator?

2 Answers