One of the advantages of HRC fuse links is that they can be
used to back up equipment with an inadequate rupture
rating. briefly discuss what this means
Answer / dhedhipya
First Understand this,
Rated current of fuse: It means that the current a fuse can
withstand for an indefinite period without any undue heating
or melting.
Rupture rating is also a similar term it is the capacity
fuse to withstand the damage due to arcs created.
HRC fuse is also called High Voltage Explosion Fuses.
HRC fuse is used in Large Power Houses. The common fusing
element is silver, copper and tin. These fuses surround the
fusible link with gas evolving substances, such as boric
acid and silicon dioxide(sand). Some special type fuses
surround one or more parallel connected fusible links. When
fuse blows, heat from arc causes boric acid to evolve large
volumes of gases. The associated high pressures and cooling
gases rapidly extinguish the resulting arc. The hot gases
are then explosively expelled out of the end.
| Is This Answer Correct ? | 2 Yes | 0 No |
If i have 200 test cases and we have to execute but we don't have time to execute all testcases.within 1 hour we have to execute that testcases and prepare the test report.so how i have to resolve this problem? is there is any technique in the testing.
State norton’s theorem?
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
in case of induction motor when overload condition or any short ckt. why stator winding burn not to be rotor winding
working principle of AC Servo Motor with its construction
why open circuit test is conducted on hv side and short circuit test is conducted on lv side of a transformer ?what is the reason for it ?
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
the rating of fuse wire i always expressed in what?
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
Dear sir, we are getting voltage fluctuations suddenly for 2 or 3 minutes again it becomes normal. we checked each and every connection some times we are getting 110 volts like that from earth to neutral again it is reducing we are getting supply from 45 kva DG set give earthing properly.
what is the use of CAPACITOR in CFL lamp?
what role neutral plays in electrical circuit? If neutral is not there what will be the effect
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)