is there any concept of armature reaction in Induction motor?

is there any concept of armature reaction in Induction
motor?

Question Posted / yasirarain1

4 Answers
17051 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

is there any concept of armature reaction in Induction motor? ..

Answer / khan

At very low speed rotor flux oppose the stator flux

Is This Answer Correct ?

1 Yes

6 No

is there any concept of armature reaction in Induction motor? ..

Answer / dbh

Armature reaction only occurring in alternator

Is This Answer Correct ?

1 Yes

10 No

is there any concept of armature reaction in Induction motor? ..

Answer / manoj

to produce armature rection,there is must neccessary two
opposite direction field and one uni direction field,so that
only the the air gap flux will distorts.in induction motors
the field produced in rotors is opposite with armature flux
in one direction only that means only on top of the
conductors produce torq .

Is This Answer Correct ?

3 Yes

13 No

is there any concept of armature reaction in Induction motor? ..

Answer / ravikant soni

there is no any concept of armature reaction in three phase induction motor because in three phase induction motor the field due to the rotor rotate in same direction as of the stator with same speed that is with synchronous speed and hence no armature reaction is possible in induction motor

Is This Answer Correct ?

6 Yes

22 No

Post New Answer

More Electrical Engineering Interview Questions

sir i had plane to do some project with the base of hopkinson test in AC supply its possible

0 Answers

1. alternator has full load regulation of 4% when pf of the load is 0.8 lag, 1500 rpm. full load regulation of 1400 rpm for 0.8lag will be ________ ?? 2. torque angle of a sync m/c operating from a constt voltage bus is usually defined as space angle between _______ . 3. method most effective in finding out no load losses in large DC shunt motoris ______ . 4. current carrying capacity of fuse material depends on ______ . 5. coil has res. 10 ohm, inductance 1H. what wil be current after 0.1sec after switching on to a 500V DC SUPPL ? ? 6. effect of phase lag compensation on servo systems ___________ . 7. rotor of a dc machine is usually supported upon ______ . 8. DC motor is preferred to AC motor in which application ?? 9. 3 nos of 10:1 Xmer are connected in Star-Delta to supply a load at 230V.the supply voltage must be ______ . 10. voltage source produces max current in which circuit. 11. cal. power, if current and voltage are out of phase by 90 degree. 12. suitable length of Xmission line of power at 66 KV. 13. Which of the theorm helps in simple computation when the load across a ckt is varying ?? 14. what is the adopted line length for power Xmission of power by cables ??

5 Answers TATA,

and gate circuit diagram,amplifier circuit diagram

0 Answers NHPC,

what meant by Locked Rotor Current ?

2 Answers

What happen when increese more than 50HZ fequincy.

5 Answers

Explain what are inter-poles and why they are required in a dc machine.

0 Answers

Is corona effect occurs in Induction motor. pl. justify the answer.

4 Answers KPS,

how to protect transformer