Answer / binu

Mainly we see the beta ratio which should be between 0.3 to
0.8.

Answer / sanjiv

You need proper sizing for that reynolds no should be
within limits b ratio you can sacrifice in few cases to
achieve better DP.
Vendors will not offer youb ratio less than 0.2 for your
normal flow range

Answer / reddy

The range the beta value is restricted to between 0.2 up to max 0.7 for accuracy and linearity

Answer / vijay

mainly depend type of orifice & beta ratio .4 to .8

Answer / pasuvaraj

beta ratio 0.4 to 0.65, this gives the perment pressure
drop across the orifice, internal bore of orifice plate

why gray colour is choosing to all instrument panel.why not choosing other colour?

1 Answers   Reliance,

Draw a group of instruments interlocked to a Pump & Motor?

0 Answers  

what is the tempareture conpensation?what is the use of this?

1 Answers  

what is the reason while warning lamp is on while the engine is cranking?

0 Answers   Jindal,

WHAT IS THE DIFFERENCE BETWEEN PLC AND DCS

55 Answers   ABB, Adani, Adani Power, GMR, IIUC,

what is the difference between the microcontroller and PLC?

9 Answers   HAL, Havells,

HOW CAN I CONNECT ROSEMOUNT 3300 LEVEL TRANSMITTER TO Allen-Bradley SLC500

1 Answers  

what is pyrometer? which purpose it has to be used?

2 Answers  

why 4ma show higher zero ? i have transmiter flow renge 0-1000 m3/h but 4 ma show in monitoring 200 m3/h and 20 ma show 1000 m3/h i want when 4ma show 0 m3/h and 20ma 1000m3/h

3 Answers  

how to use level tranasmitter in closed tank application.?

3 Answers   Dalkia,

why is an oxygen sensor used in a boiler stack

2 Answers   HCL,

An RTD is a_________________________.it works as follows

2 Answers