Interested to Buy Any Domain ? << Click Here >> for more details...
Can any body give detail about orifice sizing?
- 5 Answers
- 10503 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / binu
Mainly we see the beta ratio which should be between 0.3 to
0.8.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
How hart protocol can be connected with control valves?
How to calibrate Toxic gas detector?
What are the interlocks we have to check during the start up of LP/HP compressor?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
how u calibrate pneumatic n motorized c/v?
What is the use of single seated valve?
Pl send the model question paper of mahagenco account officer post
components of control circuit belongs to control valve
what is the diffrence between pressure safety valve & pressure relief valve....pls
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
what is RTV function in in process control?
