v=I*R, i.e V is directly proportional to I. now P=V*I. so V=P/I. thus v is inversely proportional to I. so what is the correct one? If both are correct than for which kind of condition this 2 differ

3 Answers  

---

we know that dc motors are more superior then three phase induction motors in torque generation though they are not much used in industries why?

5 Answers   Essar, L&T,

---

what is lumped and distributed elements?

0 Answers  

---

can we use 220 volt 15 w a.c. lamp on 220 volt d.c.

6 Answers   TCL,

---

What is the power factor of an alternator at no load?

0 Answers  

---

The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.

0 Answers  

---

what is the purpose of high speed earth switch in gas insulated substat

0 Answers   ABB,

---

A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?

0 Answers  

---

what is the best way to start a 15 KW motor for pump star-delta or direct on line ? and from how many KW i must use direct on line ?

1 Answers  

---

Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing

0 Answers  

---

What is the function of interposing current transformer?

0 Answers  

---

I want to know what must the CT ratio be on a load of 300A is a 3PH nutral to earh installation?

4 Answers  

---