Answer / sandeep patel

first prepare I/O list, then do cabling from and to I/O modules. after cabling do Ioop checking and do programming as per requirement of process sequentional operation and then..then take trails...

Answer / aashish

Step:
1.Define objective e.g. if temperature of heater goes
beyond 200 degree celcius the fan made on untill
temperature reaches 150degree celcious.
2. then the given objective is converted in programm by
using set of instruction it may be Plc programming language
s5 or s7 in Ladder logic or STL
3. install program into plc using required input from
module.
4.then start plc it works as per instruction.
5.Requred to connect plc output to field contactar,
6.connect sensor feedback to plc system.

Answer / raviunique2@gmail.com

plc installing is done through via codings it means plc is
nothing but the device and combination of software and
hardware codings means the normal c program is installed in
hardware according to their requirements ..........

can any one give me the cost price of yokogawa & rosemount transmitters

4 Answers  

---

What is the use of gauge?

0 Answers  

---

why bevelling is done in an orifice ?

4 Answers   ABB,

---

A temperature sensor (RTD) connected via a temperature transmitter is adjusted to give an output of 4ma at 60 deg and 20 ma at 600 deg. This output (4-20ma) from the transmitter is connected to an IGBT-inverter to control a high speed (-12,000 to +12,000 RPM) DC motor. And in the inverter it is programmed as, for 4ma the motor speed will be -3,000 RPM and for 20ma the motor speed will be +10,000 RPM. The question is : If the motor speed is +5,500 (RPM), what will be the temperature? (-sign indicates that the motion is in reverse direction).

9 Answers  

---

What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?

0 Answers   Engineers India Limited,

---

what is the basic working principle of I/P and Positioner in any control valve.

12 Answers   Essar, Visa Steel,

---

Consider a control valve action,the inlet air pressure is only 6 ksc but physically how it can be operate against 100 ksc line fluid pressure?

2 Answers   SCS,

---

what effects a surging can produce in the compressor

0 Answers   Nemat,

---

What is the difference between modbus,fieldbus & profibus

0 Answers   NSL,

---

what is interlock ckt? why it is necessary in industrial machines ?

2 Answers   IOCL,

---

What is zone,loop/fire alarm system?

0 Answers   Emco,

---

The wire is disconnected from the temperature sending unit (magnetic gauge). A voltmeter connected to the wire reads 0v. What does this indicate?

2 Answers  

---