Answer / mrudang

u mean what is tan delta ???

tan delta is dissipation/loss factor of insulation
we want to know what is condition of insulation in
equipment

and u want to know more detailes mail me

malavtrivedi2002@gmail.com

Answer / ragahvendran

TAN DELTA test are also performed in Transformers like in
motors to evaluate the condition of winding Insulation and
Bushing Insulation Strength in transformers.A DC voltage is
applied across the terminals and the value of leakage
current is noted down.the leakage current can be split into
Ic and Ir.the value of Ir should be as low as possible to
ensure that the dielectric strength is satisfactory.

Answer / sanket

Is this test mandatory for 3.3kV motor. Standards specify
necessity above 5kV, but I am in doubt why the same is not
applicable for 3.3kV motor?

what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem

0 Answers  

---

what is ground fault current? is there any current flow takes place through ground? is it possible? if it's possible whether it affect human beings on earth near the fault or not?

2 Answers  

---

Why current transformers are rated in BURDEN instead of VA?

4 Answers   Bhel,

---

What is Minimum permicible meggering value for following 1) LT Panels (Ph to Ph / Ph to Earth) 2) 11 KV, HT Panels (Ph to Ph / Ph to Earth) 3) 11 KV Cable 4) LT Cable

1 Answers   BFL,

---

wat is d diffr btw shunt coil and trip coil in VCB?

0 Answers   NTPC,

---

---

when any relay trips in any ckt then what type of setting is there in motor?what is function of relay in that ckt?

3 Answers   Finolex,

---

What is MSL designation of a motor and same may be provided in details.

0 Answers   DAE,

---

R=*¶ l/a

0 Answers  

---

What are the conditions to be satisfied for parallel operation of dc generators?

0 Answers  

---

what is skin effect

7 Answers   NHPC,

---

PLEASE EXPLANE WHAT IS " MOSFET AC CONVERTER"? WHERE AND HOW IT IS USED?

2 Answers  

---

What do you mean by dependent and independent voltage sources?

0 Answers  

---