Interested to Buy Any Domain ? << Click Here >> for more details...
What is meant by TAN-DELTA test carried out in motors?
- 3 Answers
- 18957 Views
- I also Faced
- E-Mail Answers
Answer Posted / ragahvendran
TAN DELTA test are also performed in Transformers like in
motors to evaluate the condition of winding Insulation and
Bushing Insulation Strength in transformers.A DC voltage is
applied across the terminals and the value of leakage
current is noted down.the leakage current can be split into
Ic and Ir.the value of Ir should be as low as possible to
ensure that the dielectric strength is satisfactory.
| Is This Answer Correct ? | 11 Yes | 10 No |
Post New Answer View All Answers
What is power factor why we should maintain the power factor unless what will happen
Why generation voltage in thermal power plant is between 11kv to 33kv?
we specify current in case of feeder but in case of distributor voltage, why?
What is difference between YNyn0 and YNyn ??
Graphs of measuring power and speed on dc motor
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
Explain dc generator with its types?
Sate maximum power transfer theorem?
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
what is acceptance test in electrical engineering.
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
1.WHAT IS A SMART CAPABLE DB ( DISTRIBUTION BOX) ? 2. HOW TO DECIDE THE TYPE OF DB TO BE USED ( RECESSED/ PLUG TYPE/ SMART ETC ETC? 3. WHAT IS MILLENEUM BUS BAR USED IN DB? 4.DIFFERENTIATE MCCB AND MCB.
How much no load current of synchronous motor
