Answer / p.aruna devi

No of feeder connected in a single line is known as
bus.Couple of two bus is called tie line.

Answer / sas

different bus arrangement are there.tie is only applicable
in 400kv and it is couple the two bus it is called tie.

why do we provide metallic enclosure to bus duct and then ground it?

1 Answers  

---

How could a garment factory benefit from renewable energy

0 Answers  

---

Can anyone tell me how a 12v battery is transformed to 20,000v at the spark plug

6 Answers  

---

what is earthing

1 Answers  

---

Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.

0 Answers   DAE,

---

what sis the testing procedure of transformer and ht panel?

1 Answers  

---

2 Diesel Generators 900KVA connected to the bus bar for essential load as an alternative for power taken from 11/440V 3KVA Transformer supplying this bus bar. my question here is in the event of power failure on 11KV side can I feed the power to 11 KV bus by using the same transformer as reverse feed, what will be the inrush current???

3 Answers   Ashok Leyland,

---

why should we india maintain frequency of 50 Hz.

8 Answers  

---

what is effect of unbalaced load -- say R 15A, Y 25A, B 10A

4 Answers   TransWorks,

---

why electrical power has benn needed for speed controller of woodward governor control for biomas power plant

1 Answers  

---

What is control system?

0 Answers  

---

why the 4 terminal are named as main, line, common, voltage (M, L, C, v) of a wattmeter?? why not its nameed as A,B,C,D??

6 Answers   Jindal,

---