Answer / ravi

safety is on of the main factors in idustries. If a
conductor is used to carry power, on the other hand
appropriate insulator should be used to insulate the
conductor to avoid shocks. from preventive point of view,
insulators are given first preference than conductors.

Answer / shahul snfa

its a reliability thing.. designing an electrical
instrument is important but the same time making that
instrument reliable for long life is much more
important..in this way insulators are concentrated

Answer / swetha

Selection of Insulation of conductor is depend on
Safety ,reliability,location where it is used.So electrical
engineer give more priority to the insulator then a
conductor

Answer / karthik raman.b

MR ravi's answer correct safety is the first factor cosidered in industries they have to maintain some insulation resistance value properly

Answer / harshini

Because insulators are good conductors of electricity
that's y we prefer this one.

transformer core are laminated for what purpose?

9 Answers   NTPC,

What is the rating of your capacitor bank at your company.

36 Answers   Ajnara Group, Amara Raja, Amol Electricals, Apollo, ATC, Bhagiradha Chemicals & Industries, Bharat, CBRE, Cisco, Government, JLL, MEIL, Reliance, Sterling, TNEB Tamil Nadu Electricity Board, Torrent Pharma, Victory,

Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.

0 Answers  

what is used root two in single phase line?

1 Answers   DVC,

Why design 150Hz in Exciter

1 Answers  

what mean ohm

1 Answers   Shoba Devlopers,

WHICH SUPPLY IS BETTER FOR 4 MW LOAD. 1)TO TAKE NEARER AVAILABLE 11 KV SUPPLY OR 2)TO TAKE 33 KV SUPPLY WHICH IS AVAILABLE AT 10 KM DISTANCE BY INVESTING NEARLY 50-60 LACKHS

1 Answers  

When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number

0 Answers   TATA,

What is the basic principle of circuit breaker?.. I read that it works on electro-mechanical principle... Does it require both electric n magnetic conversion to act?

3 Answers  

what is electronic regulator and how we can use that in fans?

3 Answers  

Why machines are avoided to work is saturation region of B- H curve?

3 Answers  

What is I/P converter?

1 Answers   RRDonnelley,