How does a cyclone separator work?

0 Answers  

---

What parameters should be considered while selecting type of filter?

4 Answers   Nocil,

---

Given, T1=600C, constant temperature of wall 800 , length of wit exchanger L=3m, dia=25 mm, Cp=14.91 KJ/kg.K, density ρ=914 kg/m3,mean velocity vm= 2 m/s, film heat transfer coefficient hf=72 Kcal/h.m2.K, what is the outlet temperature?

0 Answers  

---

what is difference between m3 and nm3?

2 Answers   Coromandel,

---

FOOD ENGINEERING - QUESTION 23.2 : (a) A dryer reduces the moisture content of 100 kg of a potato product from 80 % to 10 % moisture. Find the mass of the water removed in such drying process. (b) During the drying process, the air is cooled from 80 °C to 71 °C in passing through the dryer. If the latent heat of vaporization corresponding to a saturation temperature of 71 °C is 2331 kJ / kg for water, find the heat energy required to evaporate the water only. (c) Assume potato enters at 24 °C, which is also the ambient air temperature, and leaves at the same temperature as the exit air. The specific heat of potato is 3.43 kJ / (kg °C). Find the minimum heat energy required to raise the temperature of the potatoes. (d) 250 kg of steam at 70 kPa gauge is used to heat 49,800 cubic metre of air to 80 °C, and the air is cooled to 71 °C in passing through the dryer. If the latent heat of steam at 70 kPa gauge is 2283 kJ / kg, find the heat energy in steam. (e) Calculate the efficiency of the dryer based heat input and output, in drying air. Use the formula (Ti - To) / (Ti - Ta) where Ti is the inlet (high) air temperature into the dryer, To is the outlet air temperature from the dryer, and Ta is the ambient air temperature.

1 Answers  

---

What is the difference beteween in specticle blind and slip plate

1 Answers   ENI,

---

respected sir,i have been selected in the written examination prelim (CHEMICAL) of RINL(RASHTRIYE ISPAT NIGAM LTD.) held on 20 JUNE, So please tell me which type of questions will be asked in 2nd stage written exam. plz send me last 2-3 years questions asked in RINL(written exam).

1 Answers  

---

Are there any general rules that should be considered when designing a slurry piping system?

0 Answers  

---

What is the most common cause of solid size segregation in bulk solid systems?

0 Answers   TATA,

---

What are pcbs?

0 Answers  

---

CHEMICAL FLUID MECHANIC - EXAMPLE 3.3 : The drag coefficient Cd = 0.05 and lift coefficient Cl = 0.4 for a levelled flow aircraft are measured. The velocity of the aircraft is v = 150 ft / s with its weight W = 2677.5 pound-force. (a) Find the value of the lift of the aircraft, L, when it is also its weight. (b) The drag of the aircraft, D = Cd M, L = Cl M. Find the value of D. (c) The power required is P = Dv. If 1 pound-force x (ft / s) = 1.356 W, find the value of P in the unit of Watt or W.

1 Answers  

---

how many TDS & TOTAL HARDNESS, PH of drinking water is recomanded for human being use.

4 Answers  

---