Answer / manish kumar

For a dc shunt motor if field is suddenly opened, no
current flow so no flux and no magnetic field..so according
to MOTOT PRINCIPLE...conductor experiences torque only if
it is placed in magnetic field...hence the speed of motor
decreases slowly due to inertia and finally it stops.

Answer / soumyabrata banerjee

actually in case of dc shunt motor whenever the shunt field coil is open then total flux thats mainly created by the shunt fild winding is become zero then speed become dangareously high so the machine is burn out during the running condition.

Answer / ghanshyam

Is field is open.. Then whole current is flow in armature winding and we knoe that flux of dc shund moter become zero . Due to high current armature produce high speed so moter stare running in high speed condition but moter winding made for a particular current rating..... If we give a high current in armature then temp. Of winding increase and there is a possibility to insulation break down and armature winding may burn.....👍

Answer / mommen

motor will be stop suddenly

Answer / ani

motor stop

Answer / fazil

stop motor

Answer / tapeshwar pandey

If shunt field opens the residual magnetism direction will
reverse due to domination of armature reaction and motor
will move in reverse direction.

Answer / n.ravi teja

when dc shunt motor operates at normal conditions the speed
is constant.and when ever a suddenly field is open, the
field winding is having inductive property so it does not
allow sudden changes in current.open ckt means current
zero.and the rotor(armature) is continue its running
condition because it is connected to generator rotor
shaft.but we know when a current carrying cunductor is
placed in a rotating magnetic field ,it cuts the magnetic
field and emf is induced.but when field is open no current
carrying current is there in that ckt.so no emf is
induced.we know emf is proportional to speed.so speed
decreases .

Answer / raja

when the motor is under running condition suddenly the
field is open the motor will not stop.
because field is open means the field current is zero but
shunt motors are self excited motors so due to resudual
magnetism the speed of the motor will be decrease.

Answer / pavan

motor will be stoped

What is UPS and How do you maintain the UPS Maintenance? Brief Description on UPS maintenance.

0 Answers   JLL, Nokia, Uttam Galva,

Pls say , how we calculate lux / sq.ft, which formula used for calculation

5 Answers  

Elaborate the term "rotating magnetic field"

2 Answers   APTransco,

what is the difference between Earthing,Grounding and neutral?

3 Answers   Biocon, Tata Steel Limited,

we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes

0 Answers  

If R and Y terminals are short circuited,then power will cut. we all know that power cannot be stored.what will happen to already generated power at power station?

3 Answers  

What is dry and wet flashover.

1 Answers  

what is the HT motor current setting (Motor protection relay)aganist FLA If the capacitor is connected in parallal to the motor to increase the P.F from 0.89 to 0.99. the setting is to be reduced. what is the formula for to calculate the current.(FLA - CALCULATED CURRENT!= )

1 Answers  

Which one is given high energy in same power consumption AC or DC

1 Answers   Dhyey Creation,

how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?

0 Answers  

different b/w counter poise and ground wire

1 Answers   L&T, TCS,

Can I do body earthing of machine by using Cable armour or I have to run another GI wire for body earthing and how many wires I need to run. Is there any rule for this. eartnig

3 Answers   HAL,