i have 400/230v transformer and didnt done the neutral eatrhing. i connected one lamp to one phase and neutral to the earth. but the lamp is not glowing. again i connected neutral to earth and repeated the same. then the lamp is glowing. in the first condition i tested with a line tester also, at that time the tesrer is glowing what is happening i dont know can any one help me?

1 Answers  

---

What the main causes of transient interruptions on Over-Head Distribution Lines?

0 Answers   Orion Laboratories,

---

why ht11kv supply needs discharging during shut down time

1 Answers  

---

How will polarity test of Dy5 transformer ?

2 Answers   BSL,

---

Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?

0 Answers  

---

---

Current Capacity of 55sqmm & 80sqmm conductor

2 Answers  

---

what is the VA(Voltampire)? define with calculation?

4 Answers  

---

A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is onbserved the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?

1 Answers  

---

What is the difference between single point and double point bonding. please kindly detail about bonding of cables.

0 Answers  

---

What is the high series capacitance winding on high voltage power transformer ?

0 Answers  

---

Why DG self motor winding burnt out?

1 Answers   Aegis,

---

we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.

0 Answers   ABB,

---