Answer / kalyan dilip

Surge Suppressor is used to control the current
fluctuations.In motor there will be fluctuations in current
with the change in load. So Surge Suppressor is used in motor.
In case of Transformer there will no fluctuations in current
with the change in load because voltage is maintained constant
therefore it is not neccessary to use Surge Suppressor in
Transformer Feeder.

send your feedback or your doubts to kalyan.dilip0@gmail.com

we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes

0 Answers  

---

What is the difference between electrical earthing and electrical grounding?

0 Answers  

---

which motors are used in electric traction?

1 Answers  

---

why we did not get shock by touching +ve OR -ve busbar (Which are going to supply cell voltage) of Rectifier- Tranformer in electrolysis plant?

4 Answers  

---

what will happen if secondary of potential transformer (220kv/110volt) of any metering core or protection core (cables) of any phase got earthed??

1 Answers  

---

A synchronous machines has higher capacity for (1) Leading power factor (2) Lagging power factor (3) Does not depend upon the power factor of machine (4) None of the above

2 Answers   JSW,

---

in an ac series circuit there are 30 bulbs are connected in a serial set.what will happen if one bulb is fused and we removed the bulb and reconnect with the remaining bulbs? (29 bulbs). will the brightness of other bulbs increase or not?

3 Answers  

---

there is a power transformer 66/11kV in delta-delta connection has 5 feeder coming out from the secondary side. One of the feeder in it normally loaded (loaded than other feeder)and this feeder usually trips with double OCR causing the bank transformer to trip. Now if the load of this feeder is put on other transformer then that no problems occurs on that transformer or the load. However normally all the test(IR, PI, short ckt, open ckt,grounding test and other ) has been conducted for this but evertything transformer..... I am not geting what is the actual problem...

2 Answers  

---

ow can i get certificate of competency as electrical supervisor and my diploma in electrical engineering from jalgaon.

0 Answers   ONGC,

---

What is LOP Sensor in DG??????

7 Answers   Emerson,

---

I am mechanical engineer,I need Training in Electrical & Electronics ( i.e. three days workshop training ) Where will I get the same Please suggest?

2 Answers  

---

What is the maximum load of 240mmsequre single core cable can carry?

1 Answers  

---