Answer / nn mohanta

Equipment size will be larger incase of 110V equipment
because it will draw more current for the same power in
comparison to 220V supply.

Answer / asd

most easiest way use multi tester.. ^_^

Answer / brunmart

One instance is the equipment supplied power plug. each plug type has its own identity on their voltage rating if without available equipment name plate.

Answer / vikramsena_reddy

for blind if equipment is made in USA, JAPAN, KOREA that
should operate on 110/220v.

What happened when we give 2 phase supply to a 1 phase equimpent. It's effect on equipment's efficiency and life?

5 Answers  

---

what is advertised hop count

0 Answers  

---

How can the direction of a three phase induction motor be reserved

4 Answers  

---

why we use MV panels??? what's r all the needs

4 Answers  

---

Can the same motor be operated in both direction ?

12 Answers  

---

What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current

0 Answers   ABB, Jindal,

---

the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?

0 Answers  

---

What is the use of core in the transformer?

19 Answers  

---

WHEN SINGLE PHASE SUPPLY AS 220V, WHY THE 3 PHASE- 4 WIRE MEASURED AS 440 VOLTS INSTEAD OF 660 VOLTS (220 VOLTS PER PHASE i.e 220x3 = 660 volts ).

1 Answers  

---

What do you mean by passive circuit elements and why these are called passive?

0 Answers  

---

How can you calculate in detail the VA burden of current transformer used for Restricted earth fault protection? Please understand that the CT required here is Class PX or X. Also please show the calculations for knee point vtg, stabilizing resistor, magnetising current.

3 Answers  

---

What is the difference between acs 550 & acs 850

0 Answers   Madhucon,

---