What is an Automatic Voltage Regultor & what is its use?
What are the general componets we use to design an
Automatic Voltage Regulator..What are the factors to be
considered for its design?
Answers were Sorted based on User's Feedback
Answer / dheeraj
It is the device which controls the output voltage
(constant) and power factor (reactive power) of the
sysncronous machine with change in Machine load condition.
AVR helps to maintain constant output voltage of Machine
irrespective change in Machine load condition.
AVR is been design on the basis of machine rating ie. what
is machines output power(MVA),voltage and cureent as well
as rating of exciters etc.(ie. voltage and current).
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / heeth
they control the field current in an alternator so that the
output voltage in an alternator is constant w/o any
fluctuation.. its a closed feedback loop..
Is This Answer Correct ? | 3 Yes | 0 No |
AVR means automatic voltage regulator.they control the
field current in an alternator.in this Avr first develop
the excitation voltage i.e.54to59v then produce full
voltage. first supply to d.c voltage 7-8v.rectifer use in
that sustem
Is This Answer Correct ? | 0 Yes | 1 No |
How many power required for 1.5 to Airconditioner?
1 Answers College School Exams Tests,
What is the purpose of starter and choke in tube light?
9 Answers Chimay Brewery, TATA, TSPL,
who can measure the size of power cable?
how we can to the synchronization in transformer. What are the conditions for that.
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
in 3 phase induction motor resistance value is how much
Is voltage & potential transformer are the same? Are they used for same application ?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
how inductance related to number of turns in a choke
eddy current losses depends on?(a-max magnetic feild,b-avg magnetic feild,c-on frequency,d-on square of frequency)?
WHAT WILL HAPPEN WHEN THE MOTOR FREQUENCY INCREASED OVER THE RATED MOTOR RPM THROUGH DRIVE?
what is induction furnance? how many phase supply given io its coil for 15 or 20 ton furnance?