Answer / manish kumar meena

here you are saying about parallel operation,in parallel
operation conditions ae that
1) frequency should be same.
2)operating voltage must be same.
3) phase sequence must be same.
so these factors must be considered,in second part if VAR
flow is less then you have good power factor,and if VAR
flow is more then you have not that much good power factor.

how load of a turbo generator can be increased

0 Answers  

---

What is dynamo?How it works and what is the function of dynamo in a DG.

3 Answers   Amrapali,

---

what types of load we get from the national grid? is this capacitive or inductive?

1 Answers  

---

At present how many HVDC lines are there in india

18 Answers   HAL, Infosys, KSEB, Kuntham,

---

In case of a synchronous generator carbon brushes, some brushes expire before the others. Why is so? When all the brushes are installed at the same time, why don't thee expire at the same time?

1 Answers  

---

What is difference between YNyn0 and YNyn ??

0 Answers  

---

WHY WE USE CABLE JUNCTION AFTER BETWEEN TANSMISSION LINE AND TRANSFORMER

1 Answers   L&T,

---

what is ratio of copper wire size and current ?

0 Answers  

---

what is the function of RVT

4 Answers   RMSI,

---

How to increase the kvah ?

1 Answers   IGP,

---

Dear All, In a 400V power system, ratio of three current transformers installed incoming switchgear is 4000/1. Maximum three phases short circuit current of this system is 48kA. One CT is installed on neutral of upstream transformer (6/0.42kV, solidly earthed) for 51G protection. Would you please inform me about the correct CT ratio of this current transformer (on neutral)?? Thanks a million

2 Answers  

---

What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?

0 Answers  

---