Answer / k. aditya

As d.c is given to the transformer a steady flux is draws
and the primary induced emf e1 is 0. so, there is no
limited current and the resistance of the winding is so
small and the wdg may damaged

Answer / vibhor jain

as dc current flows through a constnat rate so there is constant magnetic flux folws due to which heat is produced which causes the burning of trnsfarmer

Answer / bin

transformer secondary coil produced emf depends on change in magnetic flux in the circuit.according to Faraday's law of electromagnetic induction says that emf= -n d(Q)/d (t). where Q=flux.so in dc circuit frequency is not produced.so flux is not produced hence no change in flux.i.e. emf=0. even after some times coil may be burnt due dc supply running.

Answer / mahesh rathod

in the case of DC the flux produced is steady,which doesn't
induce any emf in the primary& secondary wdgs
in the absence of prim emf,the wdg draws high magnetising
current from the source which burnts the prim wdg.

Answer / love007

DC current is use current is contsant so contant magnetic
flux due which high heat produce which me burn Xmer

Answer / tejesh

transformer include inductor action so it doent allow dc
current

Answer / aruna devi

there is no flux in DC.

How a ship getting grounded

2 Answers   Deltin Jaqk,

what is the relation between Sq mm of wire and its current carrying capacity?

5 Answers   Finolex,

why circuit breaker closing time is always higher then tripping / opening time.

13 Answers   United Phosphorus,

what happens if sf6ckt breaker gas pressure is high or low about the actual rating of gas pressure(5kg/cm2)

2 Answers  

what is induction relay

1 Answers  

Can u explain : what is supply for train (whether a,c or d.c ).I know that supply is 25000v a.c .But there is rumour that supply is D.C. And also explain how lights and fans inside the trains are working ,and what type of motors are used in trains whether D.C motors or induction motors .If d.c motor, how it gets supply.If traction motors are used then what are traction motors and its functions and how it differs from other motors and also explain about locomotive . please reply..............

9 Answers   NTPC,

why only exciting current is shown not primary current in transformer???

0 Answers  

I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?

0 Answers  

What is different between MCB & MCC & isolator switch

1 Answers   Standard Chartered,

How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend

0 Answers  

what is transformor oil gread

0 Answers   Idea,

Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?

0 Answers