Interested to Buy Any Domain ? << Click Here >> for more details...
why DC current not used in Transformer action?
- 17 Answers
- 23280 Views
- Engineers India Limited, I also Faced
- E-Mail Answers
Answer Posted / vibhor jain
as dc current flows through a constnat rate so there is constant magnetic flux folws due to which heat is produced which causes the burning of trnsfarmer
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
what is the reqirred voltage in HT motor to get full RPM on no load test?
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
What is the basic principle of welding process?
What is the difference between hot and cold loop testing?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
what is the current density of copper & alluminium.
which is better to use svc or synchronous condenser why ?
explain the mode of metal iranafer in Co,welding
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
How can ou verify the size of conductor 50Sq.mm ACSR
Why does the adjacent zone of protection overlap?
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
