what u meant of power plant?
Answers were Sorted based on User's Feedback
Answer / prasant
power plant is a place where electricity is generated
through any resource.Energy is distributed to various parts
through transmission lines.
| Is This Answer Correct ? | 9 Yes | 0 No |
Answer / shinyvikram ganji
a location where a power or energy is generated by
utilizing the earths natural resourses(renewable and non
renewable).the component of generting power is the fuel and
generator
| Is This Answer Correct ? | 6 Yes | 0 No |
Answer / pankaj
where electricity is generated
through any resource & Energy is distributed to various
parts.
| Is This Answer Correct ? | 5 Yes | 0 No |
Answer / ravi693
Where electricity is generated is called power plant
| Is This Answer Correct ? | 7 Yes | 3 No |
Answer / mukhesh
it is power is devoloped in that plant useing electrical
equpiments and then tranansmitt power to disturbutor on
economical basis
| Is This Answer Correct ? | 3 Yes | 0 No |
State norton’s theorem?
hou we find and calculate the maximum lode capesity of transforer?
what is the current setting for different relay protection for transformer .
What are the special cables required for explosion proof wiring?
Explain forward resistance, static resistance and dynamic resistance of a pn junction diode.
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
What is NUMBER OF RUN for power cable means?
What is the basic difference between the electrical engineering and electronic engineering?
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?
why is neccessary Tap changing of power transformer with in a certain time
why we use delta connection in transformer
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)