Answer Posted / pankaj
where electricity is generated
through any resource & Energy is distributed to various
parts.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
limitation of conductor height on ground when we consider EMC
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
how to calculate power consumption in slip ring motor at different step
Refernce currents are to be generated using refernce cueernts how can this be done??
What is the function of under voltage release ?
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
What is the maximum breakdown voltage of 11KVA and 66 KVA power line and how it is calculated?
WHAT IS MEANT BY SHEATH VOLTAGE IN 132Kv cable?
i m doing DEEE in part time,can i join regular cources in BE,,IF i join what the cources can i select like (civil,ece,IT) ,,kindly advice
hai iam arunkumar. i have applied for an section enginner in rrb. i want lat 5 years solved question papers. if u have please sedn it to arun30682@gmail.com
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
how to increase senstivity of ct
