Answer / malay adhikari

Due to the low voltage motor will consume high current. alsoo
it will get too much heat compare than other motors. Motor
life will be reduce and winding will be shot with earth.

What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?

0 Answers  

---

Why celing fans will rotate slowly after some days.?

2 Answers  

---

can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com

0 Answers  

---

1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?

0 Answers   IBM, Kirloskar,

---

how do you find making current and breaking current of the circuit breaker

1 Answers  

---

What is meant by stator? What is meant by rotor?

0 Answers  

---

some times voltage does not built in small generators why ?

2 Answers  

---

For Bus duct hi pot test, where we want to connect the return and ground leads?

2 Answers  

---

how line turns ratio changes in 3 phase with change in connection

0 Answers  

---

how to calculate knee point voltage of current transformer?

21 Answers   Bhel, Bhilai, Jackson,

---

my question is Megger of cable insulation or swgr board meggerring some values in one day 50mohms,some other day checking different values(20Mohms). this tell that some person tell that that values ok. how to identify the megger value is correct. pls tell me the answer.

2 Answers  

---

what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer

0 Answers  

---