plz do tell me therotically how to make a ckt using a pnp transistor to opera

plz do tell me therotically how to make a ckt using a pnp
transistor to operate a 24V relay. push button,diodes,
resistors,capacitor and one pnp transistors are available.

Question Posted / sorav

3 Answers
7607 Views
Siemens, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

plz do tell me therotically how to make a ckt using a pnp transistor to operate a 24V relay. push..

Answer / sonia

Apply a 24V to the base side with a resistor,emitter should
be grounded and output is taken from collector and add a
diode at collector side.Also put a capacitor for decoupling.

Is This Answer Correct ?

9 Yes

3 No

plz do tell me therotically how to make a ckt using a pnp transistor to operate a 24V relay. push..

Answer / rahul

connect transistor in emitter follower configurations
means connect E terminal to gnd. connect relay on collector
apply req. biasing vlt. to transistor .
Connect diode parallel to relay to freewheel the energy
stored by the relay coil.
Also used resister to limit the current through base.

Is This Answer Correct ?

6 Yes

1 No

plz do tell me therotically how to make a ckt using a pnp transistor to operate a 24V relay. push..

Answer / chandrajith o

circuit the pnp transistor in common collector mode.emitter directly shorted to Vcc ,use appropriate resistors to provide the potential divider bias for the base.connect the collector to gnd through the series combination of appropriate resistor,relay and pushbutton.when pushbutton is switched on ,the collector current which is approximately same as the emitter current flows,ther by the relay will be energised.use the diode parallel to relay to overcome the freewheeling effect.

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Electronics Communications Interview Questions

what is rectifier circuit?

3 Answers TCS,

what are differential gain and common-mode gain of a differential amplifier?

0 Answers

Compare and Contrast- Diffusion and Drift Mechanisms

0 Answers

Sparking occur when a load is switched off because the circuit has high a.) Inductance b.) Capacitance c.) Resistance d.) None

14 Answers Biwta, BSNL, CDS, DMRC, Infosys, SSC,

What are the main divisions of power system?

0 Answers

what is the full form of embedded system

2 Answers

Explain the operation of sequence control of ac voltage controller?

0 Answers

why we need external pull up for port 0 of micro-controller 8051?

2 Answers

I have recieved an interview call from HECL that is Heavy Engineering Corporation Ltd, Ranchi , Jharkhand. Can you please provide me some Electronics and Communication questions for preparation as early as possible since I am left with just one week.

0 Answers

master slave flipflop stores how many bits at any instant?

1 Answers Ecil,

where is the mercury cell widely used?

2 Answers

what is the difference between 5v capacitor and 5v battery

25 Answers TCS,

For more Electronics Communications Interview Questions Click Here