Interested to Buy Any Domain ? << Click Here >> for more details...
plz do tell me therotically how to make a ckt using a pnp
transistor to operate a 24V relay. push button,diodes,
resistors,capacitor and one pnp transistors are available.
- 3 Answers
- 7598 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / chandrajith o
circuit the pnp transistor in common collector mode.emitter directly shorted to Vcc ,use appropriate resistors to provide the potential divider bias for the base.connect the collector to gnd through the series combination of appropriate resistor,relay and pushbutton.when pushbutton is switched on ,the collector current which is approximately same as the emitter current flows,ther by the relay will be energised.use the diode parallel to relay to overcome the freewheeling effect.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What are the advantages of ac voltage controllers?
What is the protocol in PLC
why we use low and high radio band in m/w link at both end
Where pll is widely used?
plzz send in detail with answers of rrb section engineers model paper to my mail id sir.
Explain the output of the lexical analyser?
what is procedur of getting job in oracle for freshar engineer.
what is the use for electrical c licence
Given a light which may blink at a random time. There are two players who has to press a button when light blinks. The person who gets 20 pts first is declared as winner. Design FSM for this gaming event.
how much power is required for a 200 watts bulb if 60p/unit is observed?
can anyone help me out to get HPCL officer's trainee paper's pattern....sureshec127@gmail.com
What is firing angle?
what is ISDN-PRI Support
How to test SS7
What are the different types of communications?
