Answer / c. mak

Anchoring of reinforcing bars is necessary when the
development length of the reinforcement is larger than the
structure. Anchorage is used so that the steel's intended
tension load can be reached and pop-outs will not occur.
Anchorage shapes can take the form of 180 or 90 degree hooks.

Answer / kumar.k(kk)

The shapes can in form of L,U,staright usually devalopment
length is taken as the given tension value of such grade of
concrete

Answer / akhilesh chandra

If the actual available length is inadequate for full development, special anchorages must be provided, such as cogs or hooks or mechanical end plates.

Answer / kirishnasekar m

It is assumed that a proper structural assessment of the
structural elements to be subjected to the repairs will be
carried out by qualified engineers and that the choice of
the products and systems to be used, as well as the design,
is based on this assessment.

Answer / selvamani

ancorage bars are necessary to provide bond between the
concrete and the bars....

Answer / r. s. verma

when horizental and vertical membres are combined and that
reinforcement is called anchorage bar it prevent to splite
from concrete its shape can be straight L , U as per
location

What is lever arm distance

1 Answers  

why 50% more is assumed while calculating dry volume of coarse and fine aggregates in concrete calculations.whether 50% more is correct? How is it decided? whether the same is applicable to cement volume. Also what about cement mortar dr volume? How much more is to be considered for dry volume of mortar.

1 Answers  

The difference between Centering & Shuttering is –––

6 Answers   UIPL,

2. In a container filled with each of the following materials, at a porosity of 40%, determine the upward gradient required to cause the quick condition (a) Lead shot with a G = 13.75; (b) Fibre beads with G = 2.15; (c) Sand with a G = 2.32

0 Answers  

among the strectcher, header, english and flemish bond which has greater strength? where these bonds are preferred?????

3 Answers  

how many no of solid blocks and bricks required for construction of wall for 100 sqft?

14 Answers   Vipul,

what is fe 415 steel

15 Answers   L&T, Nabard, Rahul Computers,

Is there any difference in IS 456 and IRC 15? 

1 Answers  

why does only water ads in concrete?

5 Answers   L&T,

beam length 73 feet 4 inch,width 01 feet,height 50 inch so every beam load how much? and what quantity of M.S ROD? both side ony two column in middle no column.pls inform me that this is stable or not ? and how much risk of this beam?

0 Answers   Jindal,

Why was the empire state building made of steel?

0 Answers  

What are the materials used in building a gravity dam?

0 Answers