What is the main three inputs of DCS?

1 Answers  

---

how to set calibration range in a DP transmitter to measure level for a closed tank and for an open tank,and also please explain me how to set calibration range for a DP flow transmitter in a line ?

1 Answers   CCL Products, IOCL,

---

In closed loop control there are several “blocks” used to show the interactions between the process and the control system. These blocks are referred to as the “process” and the “controller.” Describe the relationship between these two blocks when creating a well tuned control loop.

1 Answers  

---

wht is Zero Elevation and Zero Suppression?

12 Answers  

---

Differentiate between ultrasonic flowmeter and radar type flow meter

0 Answers  

---

how to calibrate bubbler type level transmitter of rosemount make and how to set air flow according to the range.. give one calibration procedure with one example

1 Answers  

---

how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?

0 Answers  

---

What the basic of communication?

4 Answers   Schneider,

---

i want the equation of this question. Tranmitter range is 120 mmwc and dcs flow range is 1700 nm3/hr. if i want to change dcs range from 1700 to 2400 nm3/hr then how much dp i have to enter in transmitter

2 Answers   GMR,

---

Intools training

1 Answers  

---

IF TX SHOWS SLOW RESPONSE, WHILE A CLOSE LOOP AND WHEN WE PUT THE CONTROLLER ON MANUAL THE PROBLEM RECTIFIED, SO WE CAN SAY THE PROBLEM IS IN

1 Answers   IFFCO,

---

7. What are tri-state devices and why they are essential in a bus oriented system

1 Answers  

---