Answer / mohit kumar

multiple both the fraction with 10 and then calculate average of resulatant two no.s..... that will be your cgpa

Why we are using temperature and pressure as a reference when measuring flow of steam?

4 Answers   Shell,

---

What is the role of Integral in pid control?

6 Answers  

---

Name four general (not technical) criteria that would you consider important, when deciding upon a particular control valve?

1 Answers  

---

What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)

0 Answers  

---

why we use the 4-20 mamp signal used for transmitter.

5 Answers   Tecnimont,

---

What output voltage the proximity switch shows when it is in open enviornment?

1 Answers  

---

How can I read the electrical drawing easily?

2 Answers   Plot Enterprise,

---

what is the difference between magnetic flow meter and mass flowmeter

0 Answers  

---

where cn i find the previous years question paper for psu exam???????//

0 Answers  

---

what does mean by analog output trim and where this one used for?

1 Answers  

---

You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground

1 Answers   EIT,

---

how does pressure is converted into milli amps in pressure transmitter? plzzz explain practically

1 Answers   rsystems,

---