can you give main difference between ELCB And RCCB?
Answers were Sorted based on User's Feedback
Answer / jagun lutchman
An ELCB operate when leakage of current from phase occurs
and RCCD operate when there is a difference of current
between two phase.
| Is This Answer Correct ? | 3 Yes | 5 No |
Answer / makga
Please dont just type abreviation we want to see what are
you talking about
| Is This Answer Correct ? | 0 Yes | 3 No |
Answer / pankaj kamble
ELCB IS WORKING MAINLY DIRECT OR INDIRECT SHOCK CONDITION &
NO NEED TO CONNECT EARTHING TO BODY,RCCB ALSO PREVENT
DIRECT OR INDIRECT SHOCK CONDITION BUT COMPULSARY
CONNECTING TO EARTHING TO BODY.
| Is This Answer Correct ? | 5 Yes | 9 No |
Answer / pravesh
both rccb and elcb are same name given to the same device
both work in residual current value of the circuit. both
has low current setting i.e. 80 ma .if any durrent flows
(residual) itflows from the earth condutor and thus trip
the elcb/rccb
| Is This Answer Correct ? | 7 Yes | 28 No |
Answer / raju
elcb and rccb is working in earth lekege current no
different is rccb and elcb
| Is This Answer Correct ? | 16 Yes | 104 No |
Answer / pavan
No difference both are earth leakage protection device.
| Is This Answer Correct ? | 37 Yes | 197 No |
Answer / parmar jignesh
there is no different between ELCB & RCCBIT JUST TWO NAME
OF ONE DEVICE
| Is This Answer Correct ? | 98 Yes | 314 No |
What is mathematical model of a control system?
what is range ACB
what is differential relay in power transformer??
low voltage grounding is done by?? 1)solidly gnd 2)ressistance 3)reactance
how we can save electrical energy in industries,please give some inputs
Load break swicth maintenance procedure.
Mr. mohh sahid m not satisfied for ur answer to the que weather the size of transformer increases or decreases withchange in fr for more detail go to the answer given by me
A circuit breaker is a
what is first pole to clear factor
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
why 3 phase motors are preferable over single phase motors ?
there is a line fault some where on the ove head distribution line. how will i locate the fault for clearing it? ofcourse i have to megger the line but what information makes me clear that the fault is in that section of the line?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)