why voltage drop if we have connected 230 v ac suplly
through diode to bulbe we found haft ie 110 voltage drop
why it is
Answers were Sorted based on User's Feedback
Answer / daher
the measuring tools is reads the RMS value or the average
value. the diode is unidirectional device or one way
direction,so yiu read only the half of 230v ac on the bulbe
| Is This Answer Correct ? | 6 Yes | 0 No |
first u have to know about diode function. the diode
conducts only half of the sinusoidal wave that's why
voltage will be half at the bulb.
| Is This Answer Correct ? | 5 Yes | 1 No |
Answer / ashish
As we know that diode is a unidirectional static device.
Hence it act for the half cycle of alternating current
| Is This Answer Correct ? | 4 Yes | 0 No |
what is carona and how is occur?
6. A DC AMMETER HAS R=0.1 OHM & CURRENT RANGE IS 0-100 A IF THE RANGE IS TO BE EXTENDED TO 0-500 A THEN METER REQUIRES SHUNT RESISTANCE OF ..........
What are the main faults of DC generators?
0 Answers Mercantile Marine Department,
I have carried out wiring for lighting in a shed in Industrial area which contains Metal halide lamps & have balanced in 3ph.Now when we put all the lines on in the daytime the current taken at 3phases at MCB comes to be equal i.e.28,29,28Amps respectively but in the night time i.e between 7p.m.to 11p.m. at the same MCb the current is 52,59,62Amp, though I have fit 63A MCB it is tripping in the above period.What may be the reason.? Note: This industry is located in industrial area where majority of steel ingot manufacturing plants are there. Whether this may be due to harmonic? what should I do to overcome above problem.pl suggest urgently.
How many sprinklers should be in one pipe line?
what is on line transformer and off line transformer.
we all know that corona is nothing but ionization of air around the conductor and there by allowing current to pass through ionized air.but we are not getting any short circuit in between the respective phases though the air turned as a conductive media between them??
How the Transformer oil testing is done & Why oil dielectric goes LOW & what is solution for that ??
Explain what is CBCT.
What is the difference Marshaling box and RTCC (Relay tap changer circuit) Panel of transformer ?
how do we calculate of transformer in va?what is calculation?
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)