Interested to Buy Any Domain ? << Click Here >> for more details...
why voltage drop if we have connected 230 v ac suplly
through diode to bulbe we found haft ie 110 voltage drop
why it is
- 4 Answers
- 7068 Views
- I also Faced
- E-Mail Answers
Answer Posted / daher
the measuring tools is reads the RMS value or the average
value. the diode is unidirectional device or one way
direction,so yiu read only the half of 230v ac on the bulbe
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
Why the power generated in dams is complex power? Why the generators in dams cannot produce Real power directly (i.e power which has zero reactive part)?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
Is a d.c.compound motor is use as a booster? how?
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
-How do you select cable size for a given load at a given distance from source of supply. How do you find voltage drop.
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
What is the ideal position cooling fan inside the dc motor?
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
