How will we know in which direction a liquid is flowing in
a pipe?
Answers were Sorted based on User's Feedback
Answer / mahboob pasha
Flow happens only due to the potential difference but by external means it can be from low head to high head such as pump. so that by considering the head as well as external means we can find out the direction of flow.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / naveen
Its not only the pressure, but also entropy can be used to
find the direction of flow. Flow will be always from a
region of less entropy to more entropy
| Is This Answer Correct ? | 2 Yes | 3 No |
Answer / ram
@ answer 18
Remember "the total entropy of the universe("system + Surrounding") MUST always increase. But considering the flow as "system", its net entropy may still decrease ( eg. due to friction losses )
| Is This Answer Correct ? | 0 Yes | 1 No |
Answer / taranjit singh
As we know liquid always flow from high pressure region to
low pressure region. Therefore the liquid will flow towards
that direction where the pressure will be low
| Is This Answer Correct ? | 6 Yes | 8 No |
Answer / muthuraman
fluid flows from high pressure to low pressure
| Is This Answer Correct ? | 6 Yes | 9 No |
Answer / k.harindra kumar
flow of fluid depends on its head(elivation),pressure head,
velocity head by applying bernoulies equation we can
justify the pressure and confirm if.
| Is This Answer Correct ? | 3 Yes | 6 No |
Answer / karthick
its very simple i just measure the pressure between any two
ends.because whenever there is a difference in pressure the
flow occurs.so if the pressure is high at one end and low
at other end then the flow takes place from high pressure
side to low pressure side
| Is This Answer Correct ? | 0 Yes | 4 No |
Answer / guest
Depending upon the direction of delivery and towards the
end flow direction
| Is This Answer Correct ? | 6 Yes | 12 No |
"How to check the diode, fuse and bearer switch?"
When repacking a valve the rings of packing should be oriented so that the packing ends are installed ____________.
Machine tool guideways are usually hardening by ?
conductivity of porous substance like sponge is depended or independent of pressure?
What is a diaphragm?
When a 30KW/3 ph pump runs one hour continously, what will be the heat dissipated? how can i find this, any general equation?
How can caliberete the gas volume.
what is meant by one ton Air conditioner, how fast it cool a room.
Can some one please show me the design of a POT Bearing.
0 Answers General Motors GM, GM General Motors,
What are the types of sensors?
What is the tolerance allowable for ISMC 150(c-channel) as per IS 2062? I want the min and max dimension allowable in raw material?
what amount of heat energy loss in ESP?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)