Answer / kandula bharadwaj

For transmission of electrical power from one substation to another substation relay can be used

Answer / milan

A relay is a protective device which senses the fault
current or voltage and operates the circuit breaker to
isolate the equipment from the system.

Answer / bikash chandra pal

It is a device which generate & send some desired output
signal on receipt of desired input signal & comparision of
the same with some preset value/Data, based on it's inbuilt
logic.

Answer / gopal

A RELAY IS A PROTECTION DEVICE , WHICH PROTECT THE WHOLE
SYSTEM TO A FAULT . IT WORKS LIKE A AUTOMATIC SENSOR , WHEN
ANY FAULT OCCURS IN SYSTEM IT SIGNALS TO VCB AND ISOLATE
THE FAULT.

Answer / saravanakumar

relay is a protecting device. it will measure the fault
current present the circuit, and then operate the circuit
breaker contacts to remove the faulty portion from the
circuit

Answer / g.balaji

Relay is a sensing device which senses a particular circuit
condition(eg:DC/AC Voltage & Current) and changes the
status of its contacts(eg:NO to NC,NC to NO)by which it
operates the auxiliary devices connected to the contacts.

Answer / suresh

A relay is a sensing device which actuates on fault current.

Answer / fayaz

relay is the switch it was re laying the eletricakl
circuit ofter every operation for next operation

Answer / ankaraju.k

It is actuating device for the circuitbreaker

Answer / ss

relay is switch

how can we choose the size of road crossing pipe for power cables

2 Answers   DLF,

What will happen if we give 220v supply on both sides to the bulb

7 Answers   Exide, Sumeet Industries, Toshiba,

how i run d.c. moter with solar panel without use of battery?

1 Answers  

What is the cause for a blown fuse in one phase of primery side(HV) of a three phase transformer( 4169v-460v) in the time of closing its supply breaker. There is no load on the secondery side of the transformer in this moment.

3 Answers   Novachem,

I have a one P.F meter in my factory showing 2 phase leading and one phase lagging then what is my actual P.F.

1 Answers  

what is the ideal earth resistance

11 Answers   Amit Enterprises, Enercon,

practically What is power factor

6 Answers  

why the efficiency of the dc machine is high ,when it is operated as a generator?

3 Answers  

what is meant by Hrc fuses.?In the distribution system different rating hrc fuses are used for tranformer(which is 3k,6k,10k,15k etc).what is k?.plz any brother tell me about k?

1 Answers  

if acapacitor connected to power supply will it cosume power& will it going to get recorded in energy meter

2 Answers  

What should be the value of earth resistance for an instrumentation/electronic circuit? As per which IS/IEC Code?

3 Answers   IOCL,

for measuring current and etc.,why we use value of 1.732 in three phase calculation. not in single phase.why

3 Answers   Bhel,