capacitor is load free component but why ampare meter shows
the current when the capacitor bank breaker close?
Answers were Sorted based on User's Feedback
Answer / nagendra
Whether inductive or capacitive the load is,the ammeter
that is connected in the circuit will continue to deflect
its needle.Means the ammeter measures apparent current in
the circuit.It doesnt matter to the ammeter whether the
current leads or lags the voltage.
| Is This Answer Correct ? | 4 Yes | 1 No |
Answer / anurag
capacitor is not an inductive component and hence load free
but shows current because it draws leading current.
| Is This Answer Correct ? | 3 Yes | 2 No |
Answer / sujeet kumar
as no component is ideal due to lekage resistance of
capacitor ampare meter shows the current
| Is This Answer Correct ? | 2 Yes | 2 No |
Answer / mohit
as we know that capacitor stors the charge
acc to relation
Q=I*T
or I=Q/T
hence the current will flows
| Is This Answer Correct ? | 1 Yes | 5 No |
What are the disadvantages of hydropower?
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
How to design power source say 5KW i/p :415v 3 ph, o/p 5KW constant, variable currnt and variable volatge 10-230v,
WHAT IS MINIMUM AMOUNT OF CURRENT THE HUMAN BEING CANT RECOVER FROM THE SHOCK,WHAT IS THE RESISTANCE OF THE HUMAN BODY
how does an open delta transformer works
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
how the transmission voltage ranges are decided like 11kV,33kV,66kV,132kV,220kV,400kV,725kV.... why not choose the transmission line voltage as 23kV,164kV,440kV?? what's the reason??
What is meant by transformer, why it should be used, with out that equipment what happens if we transformed the supply?
What is stray looses?
Waht are the protection should be use in HT/ LT side of the same Xformer?
where used of HVDS system.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)