A cylindrical vessel of 10m height has water upto 6m and is under a pressure of 15bar.What will be the pressure at the bottom most point of the vessel?

4 Answers  

---

ACCOUNTING AND FINANCIAL ENGINEERING - EXAMPLE 34.17 : In the engineering calculations of interest rate caused by inflation, General Inflation Effect and Fisher Effect may be considered. Let I = inflation rate, R = nominal interest rate, r = real interest rate. According to Fisher Effect, (1 + R) = (1 + r) (1 + I). According to General Inflation Effect, r = R - I. (a) If I = 0.1 for all effects, both the values of R and r in the Fisher Effect are the same as R and r in the General Inflation Effect, find the values of R and r. (b) If R has the same value caused by both General Inflation Effect and Fisher Effect, find the possible values of R, r and I in term of R etc.

1 Answers  

---

UNIT OPERATION - EXAMPLE 9.4 : Acetone and ethanol are separated using a distillation column with a partial condenser and partial reboiler. An equimolar, sub-cooled liquid feed enters at 100 kmol / hr and condenses 1 mole of vapor for every 6 moles of feed. The separation requires a distillate vapor that is 95 mol % acetone and bottoms liquid that is 5 mol % acetone. The reflux is returned from the condenser to the column as a saturated liquid and the operation is run at (L / V) = 1.4 * (L / V) min. Assume constant overflow conditions. (a) Feed operating line is y = [ q / (q - 1) ] x - z / (q - 1) where z = 0.5 for equimolar liquid mixture of 2 components, q = (L'- L) / F where L' = L + F + (F / 6) for condensation of 1 mole of vapor / 6 moles of feed. What is y = f(x)? (b) The rectifying operating line is y = (L / V) x + (D / V) (xd) where (L / V) min goes through the points A (0.95, 0.95) and B (0.53, 0.69), V = L + D. What is y = f(x)? Let xd = 0.95. (L / V) min is the slope of the 2 points A and B.

1 Answers  

---

ENGINEERING DRAWING - EXAMPLE 18.3 : Autocad computer program is used to draw a pipe that is used to transport natural gases for processing. Actual length of the pipe is 10 metres. The pipe has cross sectional area of circle in shape with measured circumference of s = 3 metres. (a) If 10 units are used to represent the actual length of the pipe in computerised engineering drawing, find the diameter of the pipe, d that will be shown in the engineering drawing. (b) If one unit in the program equals to 1 centimetre, find the scale used in the computer program.

1 Answers  

---

Need to design filter...Length and diamter of shell

1 Answers  

---

What are the types of membranes used in RO water treatement plant?

2 Answers  

---

Why should a magnesium ribbon be cleaned before burning in air?

0 Answers  

---

pls send me HPCL & reliance test paper for chemical engineering.....

4 Answers   HPCL, Reliance,

---

What information is needed to specify a mixer?

0 Answers  

---

Explain the working of a spray condenser?

0 Answers  

---

What is critical radius of insulation?

0 Answers  

---

what is the cast iron grade of composition of c-3.06% , Mn- 0.48% , Si-2.38% , S-0.088% , P-0.092% , Cr-0.12% , Ni- 0.012% , Mo-0.00%

0 Answers   L&T,

---