Answer / bala

no idea

Answer / ronit kumar

i m chemical engg. graduate i need hpcl paper for exam on 2011,unable to find a book for polymer

Answer / ankitgv

please send me reliance test paper for chemical engineering.....
ID:ankitgv@iitk.ac.in

Answer / radhe

plz mail me ril paper for chemical engg. of both apti & technical

sir,please give me some exam paper for referance. Thanks & Regards,

0 Answers   ONGC,

---

Define pcbs?

0 Answers  

---

PROCESS DESIGN - EXAMPLE 21.2 : The names of the flow streams could be represented by : H1 for first hot stream, H2 for second hot stream, C1 for first cold stream, C2 for second cold stream. Data of supply temperature Ts in degree Celsius : 150 for H1, 170 for H2, 30 for C1, 30 for C2. Data of target temperature Tt in degree Celsius : 50 for H1, 169 for H2, 150 for C1, 40 for C2. Data of heat capacity Cp in kW / degree Celsius : 3 for H1, 360 for H2, 3 for C1, 30 for C2. (a) Find the enthalpy changes, dH for all streams of flow H1, H2, C1 and C2 in the unit of kW. Take note of the formula dH = (Cp) (Tt - Ts). (b) Match the hot streams H1 and H2 with the suitable cold streams C1 and C2 to achieve the maximum energy efficiency.

1 Answers  

---

Question 43 - In a non-dilute absorber, the inlet gas stream consists of 8 mol % carbon dioxide in nitrogen. By contact with room temperature water at atmospheric pressure, 65 % of the carbon dioxide from a gas stream has been removed. (a) Find the mole ratio of carbon dioxide and nitrogen gases at inlet and outlet gas streams. (b) The Henry’s Law provides y = 1640 x for carbon dioxide in water. Find the mole ratio when x = 0.0000427. Mole ratio is y / (1 - y) for y.

1 Answers  

---

What is the procedure to estimate the friction factor involved in heat exchanger tubes?

0 Answers  

---

---

Explain what is a good way to get started in doing a plant-wide steam consumption analysis?

0 Answers  

---

hai i A neelakanteswara rao ,selected for the interview on 15th july 2008. I completed my diploma in chemical engineering.let me know how to face the interview& the type of technical questions.

0 Answers   IOCL,

---

ENVIRONMENTAL ENGINEERING - QUESTION 22.3 : A well delivers 225 US-gallons per minute of water to a chemical plant during normal system operation. (a) Calculate its flowrate in the unit of mega US-gallon per day or MGD. (b) The following formula is written next to the chlorine feed point : (chlorine feed rate, lb / day) = (flowrate, MGD) X (dose, mg / L) x (8.34). If this formula is correct, then what should the chlorine feed rate to be in pounds per day (lb / day) if the desired dose is 2 mg / L. (c) Prove by calculations that the constant 8.34 in the formula next to the chlorine feed point is correct. Let 1 US-gallon = 3.78541 L and 1 mg = 0.0000022046 pound.

1 Answers  

---

What is gibbs free energy?

0 Answers  

---

What is the main difference between deflection and null type instruments?

1 Answers  

---

What is the meaning of the critical speed of a turbine, and what are its effects on the shaft line

1 Answers  

---

What is the ignititon temprecher of Diesel,Petrol&Carosion oil.

0 Answers   ME,

---