What is the full form of cable type-ayry

0 Answers   TATA,

---

a high voltage electric line for showing a blinking rod but connected a single line..wht is the rods name...and explain its working

0 Answers  

---

What is the neutral voltage in practical AC systems

0 Answers   VCMS Technologies,

---

How can u find reactive loads(Kvar)?

0 Answers   econ,

---

how we can calculate the load appeared on programable logic controller.and what is the method to calculate the scan time of PLC.

0 Answers   Siemens,

---

what is the work of commutator and brush in motor

0 Answers  

---

What's is the mechanism of for stroke engine

0 Answers   Medha Servo,

---

What is sub category?

1 Answers   DBS,

---

when power factor leading above 1 than defect moter and kwh.

0 Answers   Syncom,

---

If I installed wrong directions orifice plate then what showing value d.p transmitter in D. C. S. ?.....

0 Answers   TCL,

---

Why we should not apply Ac supply to Cable when during the cable Hi pot test ?

0 Answers  

---

Question 95 - The following formula is used as a reference : (analyte signal) / (internal standard signal) = (f-factor) x (concentration of analyte) / (concentration of internal standard). A solution containing 3 mM of analyte and 4 mM of internal standard gave peak signals of 2 and 3 mamps respectively. Another similar solution containing 2 mM of analyte and 1 mM of internal standard gave peak signals of 1 and 4 mamps respectively. Find the average f-factor.

1 Answers  

---