Answer / karnam seenu

Natural ground level is a reference level used to mark the floor height for different floors. This can be done by considering NGL as Temporary benchmark and transferring to the column surface or a permanent pillar constructed and maintained till completion of the project since this reference will be taken for all marking of bottom level of slab beams, slab top level, plinth top level, footing top level, etc., by using theodolite instrument or Total station or by simple Dumpy level

Describe Briefly The Various Methods Of Concrete Curing?

0 Answers   Bechtel,

---

In footing (mat) if two different dia of rods are to be used which rod should be placed at top and bottom ( eg. 10mm & 16mm dia rods)

7 Answers  

---

In a concrete grade C35A, C & A stands for what and equalent cube strength?

0 Answers   SK,

---

what is the quantity of concrete required in 1 cubic meter volume without reinforcement

3 Answers   BLGC, TATA,

---

For The preparation of goverment examination Which book i will prefer and by which way i will do the preparation for exam.

0 Answers  

---

Deduction in length of reinforcement steel for bar bending

3 Answers   HCC, Lanco,

---

Definition of plinth beam & Uses.

4 Answers   Atlantic Projects,

---

how to convert sand in Cft to Kgs

0 Answers  

---

What is ld in beams column and slab.

1 Answers   Manas Group,

---

Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa

0 Answers  

---

If we are providing concrete joint in every 10m with water stopper in water tank wall then is it necessary to cut the steel at joint section?

0 Answers   Talib and Shamsi Constructions,

---

How much material will consume for following specification water tank (9*7.5*6 feet)?

0 Answers  

---