What is the maximum advisable distance where it is required to interconnect a 50

What is the maximum advisable distance where it is required to interconnect a 500 KVA 480 V 3 ph transformer and the main panel or MCC ignoring the voltage droop affectation, does it is exist any standard about it?

Question Posted / perladelsur

2 Answers
2225 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is the maximum advisable distance where it is required to interconnect a 500 KVA 480 V 3 ph tra..

Answer / perladelsur

Thanks Mr VinotKumarkkp for your comment but I think there are other reasons like to reduce the shortcircuit inpedance toprotection accurancy and other effect that I am trying to find out
Bye

Is This Answer Correct ?

0 Yes

0 No

What is the maximum advisable distance where it is required to interconnect a 500 KVA 480 V 3 ph tra..

Answer / vinodkumarkkp

This is totally dependent on voltage drops. But u dont consider voltage drops then one main reason is also that hv conductor size is less than lv conductor size. I think this is reason.

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit

0 Answers Machino,

Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC

0 Answers Shree Mayur Engineering,

What are the difference between off-load tap changer and on-load tap changer in transformer?

2 Answers HCL,

when an induction motor runs on load.at that time if we reduce the supply voltage the current increases.But when it runs without load,if we reduce the supply voltage the current also reduced.why?.i checked it practically also.

1 Answers Birla,

how to select electronic timer(Star-Delta) setting for diff. rating motors

0 Answers Getrag Ford Transmissions,

1.what is the contact resistace of CB ? 2.radioactivity should be mesured with---------?

3 Answers Power Grid,

1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.

0 Answers

In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is

0 Answers Caterpillar,

What are the three constants associated with a steady state error?

0 Answers

What is the effect of impedance on the heat losses in case of AC system??? Does heat losses really depends on the impedance or depends only on resistive component only..??

4 Answers

friends., why celling fan rotate cockwise direction and wall fan anticickwise direction ?

3 Answers

what is servo motor and how to work it.

0 Answers

For more Electrical Engineering Interview Questions Click Here