What is the maximum advisable distance where it is required to interconnect a 500 KVA 480 V 3 ph transformer and the main panel or MCC ignoring the voltage droop affectation, does it is exist any standard about it?
- 2 Answers
- 2226 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinodkumarkkp
This is totally dependent on voltage drops. But u dont consider voltage drops then one main reason is also that hv conductor size is less than lv conductor size. I think this is reason.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What are the advantages of instrument transformer?
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
what is (+) and (-) in generator field detector stand for?
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
On Which Pressure PRV is operated.
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
how to test the electrical panel.ht lt mcc pcc.
How to Make relay co ordination chart for a Electrical power distribution of a plant
why servomotor motor? where i apply for best output?
What is shutdown of electrical sub station?
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
can we install HT panel & LT panel side by side or how much clearance is required ?
Dear Sir I am living in Jaipur Rajasthan now I did complete my b tech degree in electrical engineering in 2012 Sir how I gate certificate of competency for electrical supervisor
how harmonics generated in induction furnance? how minimise it?
