Transmission lines usually use a.3 phase b.2 phase c. Single phase

Transmission lines usually use

a.3 phase

b.2 phase

c. Single phase

Question Posted / neduet

Transmission lines usually use a.3 phase b.2 phase c. Single phase..

Answer / ismail

3 ph

Is This Answer Correct ?

8 Yes

0 No

More Electrical Engineering Interview Questions

HAT IS THE EFFECT OF LOW POWER FACTOR ON THE GENERATING STATION?HOW WILL YOU IMPROVE THE LOW POWER FACTOR?

why we use perllel conection system in the wiring?

How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?

What is measurement?

What is the unit of vaccum?

What is the Efficiency in Electric motor ?

can i connect the two phases of scott connected transformer,if not why?

can we install HT panel & LT panel side by side or how much clearance is required ?

In our homes we place the 5Amps fuse...now in our house only takes 5Amps for all normal conditions ha???

why capacitor offer reactance to alternating current?

what parameters are should nessary for control technic dc drive(in rolling mills)?

What is George phenomena to start the synchronus machine?

For more Electrical Engineering Interview Questions Click Here